Xantrex Freedom XC PRO Marine 2000W Inverter/Charger 12V

The Xantrex Freedom XC PRO Marine 2000W (MPN 818-2015, UPC 715535912673) is a true pure-sine-wave inverter, 100-amp multi-stage battery charger, and 50-amp automatic AC transfer switch combined in one compact marine-grade enclosure – the all-in-one shore-power-to-house-battery system that powers AC appliances at the dock or under way, charges the house bank from shore or generator, and seamlessly switches loads between the two without you touching a thing. 2000 watts continuous output (4000W peak surge for 5 seconds to start refrigerator, microwave, AC compressor, or other motor-load appliances) at 120 VAC pure sine wave from a 12 VDC house battery bank with 10-18 VDC input tolerance so the inverter keeps running cleanly whether the alternator is pushing 14.6 V or the bank has drawn down to 11 V on a hard night at anchor. The 100 amp built-in charger uses power-factor-corrected multi-stage charging that pulls less current from shore power than older chargers – critical for boats running on 30-amp shore service where every amp counts before the breaker pops. Charger handles flooded, AGM, gel, and lithium-ion battery banks with configurable charging profiles for each chemistry, plus battery equalization for flooded banks and dead-battery recovery down to 0 VDC. The headline marine feature in the XC PRO over the base XC is NMEA 2000 integration via Micro-C connector – the inverter shows up on your chartplotter or MFD as a native NMEA 2000 device with battery voltage, AC voltage, inverter status, and load current data right on the helm display. Bluetooth app monitoring/configuration is available via the optional Bluetooth remote panel (808-0817-02, sold separately). Operates from -4°F to 104°F (-20°C to 40°C) at full output – actual marine temperature swing, not just lab-conditions rating. 86-91% efficiency, ignition control to auto-shutoff when key is off, programmable AC under-voltage shutdown (85-110 VAC) for weak shore power. Compact 15.4 x 10.8 x 4.9 inch enclosure mounts in tight spaces standard marine engine rooms can accommodate. Limited 2-year warranty.

The Xantrex Freedom XC PRO Marine 2000W is the all-in-one inverter/charger/transfer-switch combo unit that handles the entire shore-power-to-house-battery loop on a cruising sailboat, trawler, or larger motor yacht. Three separate pieces of equipment – pure sine wave inverter, multi-stage battery charger, automatic AC transfer relay – integrated into one compact marine-grade enclosure with NMEA 2000 network integration so the helm display can show inverter status alongside everything else on the boat.

What this product replaces. Traditionally a cruising boat needed three separate items: a 2000W pure sine wave inverter to make 120 VAC from house battery, a 100-amp shore-power battery charger to top up the house bank from dock power, and an AC transfer switch (usually manual) to move the AC distribution panel between shore input and inverter output. Three boxes, three sets of wiring, three sets of failure points. The Freedom XC PRO combines all three into one unit, with the transfer switch becoming fully automatic and the inverter and charger sharing the same DC-side wiring to the battery bank. Net effect: simpler install, less wall space consumed, single point of monitoring, and roughly 30-40% lower total cost vs three separate components.

True pure sine wave matters. Cheaper inverters output modified sine wave (stepped square wave) AC, which works for resistive loads (incandescent lights, simple heaters) but causes real problems with sensitive electronics and motor loads. Microwave ovens run at 2/3 power on modified sine. Refrigerator compressors run hot and have shortened motor life. CPAP machines throw error codes. LED TVs buzz and may damage their power supplies over time. Laptop power supplies tolerate it but inverter chargers and battery chargers behave erratically. Pure sine wave output – what the XC PRO produces – is electrically identical to shore power or generator output, so every appliance and electronic device works exactly as designed. For a cruising boat where you’re running anything more than basic lights and 12V devices, pure sine wave is required.

The 100-amp charger with power factor correction. The integrated battery charger pumps up to 100 amps at 14.4 V into the house bank during the bulk charging stage – aggressive enough to recharge a 600-800 Ah lithium house bank in a single afternoon at dock, or a comparable lead-acid bank overnight on shore power. The power factor correction (PFC) on the charger input side is the under-appreciated feature: PFC makes the charger pull current from shore power as a clean sine wave aligned in phase with the input voltage, which means the breaker only sees the actual power being consumed. Non-PFC chargers pull current in narrow pulses that look like much higher peak current to the breaker – and trip 30A shore-power pedestals when you’re only actually consuming 20A average. PFC is what lets you charge a big bank on 30A service without nuisance breaker trips.

Multi-stage charging algorithm. The charger runs three-stage charging (bulk / absorption / float) with temperature compensation for any of: flooded lead-acid, AGM, gel, and lithium-ion battery chemistries. Charging profiles are individually configurable for each chemistry via the optional Bluetooth remote panel – you set bulk voltage, absorption voltage, absorption time, float voltage, and temperature compensation coefficient to match the battery manufacturer’s published charging spec exactly. Battery equalization mode (for flooded banks only) periodically over-charges the bank to remix the electrolyte and prevent sulfation – typically 8-hour cycle once a month or per battery manufacturer recommendation. Dead-battery recovery from 0 VDC handles deeply-discharged banks that conventional chargers refuse to start charging because they don’t see a battery voltage to detect.

The 50-amp AC transfer switch. When shore power or generator AC is present at the inverter’s AC input, the built-in 50-amp transfer relay senses the incoming power and within 20 milliseconds switches the AC distribution panel from inverter output to the incoming AC source. When shore power drops (you unplug, the dock breaker trips, the generator stops), the relay senses the loss and switches back to inverter output – again within 20 ms, which is fast enough that most appliances see no interruption and equipment with internal capacitor reserves (computers, modern TVs) don’t even blink. The 50-amp rating handles all the AC loads on a typical cruising boat including air conditioning, water heater, microwave, and battery charger simultaneously.

NMEA 2000 integration – the PRO feature. The XC PRO’s NMEA 2000 integration via Micro-C connector is the headline upgrade over the standard XC line. Plug it into the boat’s NMEA 2000 backbone and the inverter shows up as a native N2K device – inverter on/off status, AC input voltage and current, AC output voltage and current, DC input voltage and charge current, charger stage (bulk/absorption/float), and active alarms all appear on any NMEA-2000-compatible MFD or display at the helm. You can also control the inverter from the MFD (turn it on/off, change charger settings) on MFDs that support the Xantrex profile. The NMEA 2000 connection also exposes the inverter’s data to third-party monitoring systems, RV-C systems on toy-hauler and RV applications, and J-1939 systems on commercial vessels.

Bluetooth app via optional remote panel. The Xantrex Bluetooth remote panel (model 808-0817-02, sold separately) plugs into the inverter and adds Bluetooth Low Energy connectivity so the Xantrex mobile app on iOS or Android can configure all inverter settings, monitor status in real time, and pull historical data. Critical for boats where the inverter is buried in an engine room locker and you don’t want to crawl back there every time you need to check status. The Bluetooth remote is highly recommended for any serious install – the LED indicators on the inverter itself are minimal.

Operating temperature range. -4°F to 104°F (-20°C to 40°C) at full output is the spec – and it’s marine-realistic, not lab-conditions optimistic. The XC PRO maintains rated output through the actual temperature swing a marine engine room sees from a winter cold-soak in a freshwater marina to a Caribbean dog-day in the engine compartment at noon. Thermal protection circuits kick in above 104°F to derate output gradually rather than just shutting off, so the inverter keeps running at reduced capacity if you exceed the rating rather than failing entirely.

Other practical features. Ignition control input lets you wire the inverter to the boat’s ignition key (or main battery switch) so the inverter automatically powers off when the key is off, preventing the inverter’s idle current draw (about 1 amp at 12 V) from slowly drawing down the bank when the boat is unattended. Programmable AC under-voltage shutdown (settable 85-110 VAC) lets you operate under weak shore power conditions where the dock voltage sags – the inverter will continue working until shore voltage drops below your set threshold, then disconnects from shore power and runs from battery instead. Power Share feature limits total AC input current to a programmable maximum, prioritizing AC loads over charger current so the charger automatically backs off when AC loads spike high enough to threaten the shore power breaker.

Physical specs. 15.4 inches long x 10.8 inches wide x 4.9 inches tall – compact enough to mount in most engine room compartments. Mounting orientation is flexible (wall, ceiling, or shelf mount) with the proviso that adequate ventilation must be maintained on the fan-cooled side. Marine-grade enclosure with corrosion-resistant powder coat finish. Connections are large screw terminals for DC (battery side), AC input, and AC output – sized for the heavy-gauge wire required at 2000W output. Note: This product may not be returned to NVN Marine after purchase – per Xantrex policy, support and warranty service goes directly through Xantrex authorized service. Limited 2-year warranty from Xantrex.